Thanks Phillippe / Francois, OK we dropped the voltage on the regulator which was set too high. Ran the alternator and reached float, red square gone ...

We were able to connect to the BMS with a PC, we updated the firmware, loaded the configuration file sent by the original installer. But we're still h...

The file is a JPG, I sent you and Phillippe the same file in an email after this topic crashed with no reply.  

Hi Francois, The monitor is showing the measurements correctly, no problem there. We tried both cables, in two different computers (Macs) and neither ...

Thanks Francois, My apologies I should have mentioned we've tried 2 different laptops (both Macs).Both laptops have up-to-date operating systems 11.17...

Hey Phillippe, I've reattached the trigger worksheet in a different format. We don't have a system Schematic but I've attached a document outlining th...

Hey Phillippe, I've attached the screenshots and the trigger worksheet. We got the H1 alarm, Not sure how the BMS cuts the power from the altern...

Hey Phillippe, So we tried charging the batteries with the alternator, same thing happened, the SOC went to 104%, we ended up getting a alarm, the B...

Hey Phillippe, I've attached a zoomed in screenshot of the current drop at 19.30 it goes down to -10A. Not sure what stopped the charger, we've use...

Thanks Phillippe, Attached,

Thanks Phillippe, We've gone through this process twice, first time we were charging with solar and second time we were using shore power and the b...

Thanks Phillippe,