@francois_tao NO, NOT WORKING AGAIN. Yesterday afternoon and evening they seemed to be working correctly. But this morning I woke up and both monitors...

@francois_tao I updated last night soon after the email came through. This morning I woke up to everything off as monitor 1 (older) had turned itself ...

Installing monitor firmware 2.04.0 has wrecked my two monitors. They are non-responsive, then responsive, then non-responsive. Older monitor loose...

@francois_tao No, no changes to the power wiring nor the monitor wiring. I have replied to Alexandre's email regarding another monitor update.

Oops, I meant to say that the negative cables join the Victron shunt on the battery side. The load side has one cable going to the negative bus.

Hi @francois_tao, the current displayed on the Cerbo is the sum of currents visible on each monitor. I'm sure that the Cerbo is measuring current for ...

Thanks for the instructions and suggestions. I checked and yes, both monitors' CAN connections do have a termination jumper installed. The CAN network...

@francois_tao What are the CAN termination jumpers on the monitors? Both monitors have two wires connected to the CAN connectors on the outside of the...

@alexandre Thank you. Are you able to advise me regarding the multiple TAO devices present in the Victron VE.Can port Devices list? After applying ...

@francois_tao After 3 hours of watching the Cerbo screen (I was doing other things in our salon, not just starting at the screen the whole time!) the ...

@francois_tao The screen calibration and visibility has gotten worse over the last 12 months. I only noticed the grey screen with blue line a few days...

I've just updated both my monitors to 2.02.13 and both my BMS to 1.36. Without having changed anything else, I now see that BMS1 is continually connec...