Hello Francis, Thank you for your reply, I removed an RJ11 end from your black 10 metre cable & pulled through my conduit beside the blue cat5E...

Thank you Francis, from Leigh Yes, I have some good shielded cable, but it has 0.5mm2 wire & I'm not sure if I can crimp it into the RJ11 co...

Hello, I have the TAO shunt circuit board connected to the Victron BMV 712 shunt & I want to do the zero current offset & zero current calib...

Thanks Phil, Your right I think it would be a high resistance joint problem. The plated copper links supplied with the cells look substandard for a ...

Hello Philippe If the BMS is operating OK as it is, do we need to do a firmware update? Thanks - Leigh  

Hello, I am thinking about using Bosch automotive relays to drive the above Kilovac contactor @12v, is it best to use diode or resister protected mode...

I am wondering if this hardware remote switch off of the above, may be a bit to severe and is for last resort procedure only, as the GX device will be...

Thanks Phil, It was only someone else on the forum had used all the 6 relay contacts up ( they had a good wiring diagram ) I have to do one now. I t...

Thanks Phil, Yes I would like to use the D model & power it direct from the 48v pack, but the bit that puzzles me is the 3rd line in the coil op...