what about the required permanent power? this ist connected to "black" and "red" of the relay. so if black is already connected to GND by the perman...

  Will mounting the electronics of the TAO shunt on a Victron smart shunt work, too? And what kind of parameters has to be changed? Andre

@philtao MPPT: CANbus + relay between MPPT and solar panels (no remote control input on my older Victron MPPT) Unfortunately VE has changed the...

I didn't expect it at all, but Winston now answered my request:   "....Thank you for purchasing our batteries. Below is our reply: For sing...

We now have bought 12 pieces of Winston LYP260 AHA LiFeYPo4 for the installation (12V). I'm unsure about the right charging voltage. There are differe...

Hello Foxy Kitty, We just bought - Victron Multiplus 12/3000/120-16 because the BMS can regulate it by using CAN - Balmar 120A alternator with t...

Quote from philtao on 04/03/2022, 9:56 I am sure you realize that in case of UVP (Under Voltage Protection), the MultiPlus charger can no longer ch...

Quote from philtao on 05/03/2022, 8:58 am @leighcaldwellbigpond-com Yes, the BMS can also remote control the MultiPlus charger and inverter indepe...

V1.4 -> engine VP MD2030B added -> battery monitor for starter battery added -    

Thanks for your comments. @Philippe the MPPTs remote could be connected in 3 different ways. There are two terminals, named L and H, for the remot...

We have a small emergency battery for the VHF radio on board, which is normally not in use. It is mounted high about the water level in case of our ma...