Monitor v2.02.05: New features: when charge Cycle Management stops the charge, the charge current limit sent on CANbus is set to zero (normal op...

At the moment I use a 50A automotive relay (little cube) with NO/NC outputs, but when I have time I will replace with NCR latching relay (+ Latching r...

Thank you for your interest in the TAO BMS. The short answer is "no"... and you should not do it unless your BMS is able to balance cells across the ...

I used to have a Kilovac on my installation and never had any issue.

Why not drive the Kilovac relay straight from the BMS output? Each BMS output is protected by an internal resettable fuse at 2A continuous and should ...

@molly, Once you have the cells balanced and the system operational, you can do some testing to see how much more energy the battery accepts above a...

I have now published instructions on how to connect and configure the BMS / Victron GX so that they can communicate using CANbus. See link below: C...

Instructions have now been published on setting up the BMS and the Victron Cerbo GX so that they can communicate over CANbus. See the link below CA...

@leigh This is a good point where you need to think about the order in which the BMS takes action from the basic management all the way to last reso...

Whouaaa! Thank you @foxy-kitty for sharing this well documented installation.

For the PC connection, why don't you use the Monitor built-in WiFi. Either connect the Monitor to an existing WiFi on the boat or let it create its o...

Bonsoir Michel, Did you mean to upload a schematics? I will add the Google translation of your message into English before your original text. Li...

Hi Andres, I think it is a wise choice to double the CAN commands with the wired Victron remote on/off. What you want to do is exactly what @foxy-...

@foxy-kitty Yes, I confirm that the BMS triggers always have priority. In your example, the high temp trigger will activate the outputs as programm...

I have not yet found the perfect tool to draw installation schematics and am also interested in suggestions I have used different drawing tool like ...