Pour la charge initiale en 12V et BMS connecté, tu peux utiliser un chargeur du bateau (chargeur de quai, alternateur régulé, MPPT si il y a du soleil...

You can create the profiles you want, but I see what you might be talking about... correct me if I am wrong. At the end of the weekend you switch t...

Yes, it makes sense. The BMS will not cut when the battery is full, but when a cell reaches a set voltage (3.55V in factory settings). At that tim...

BMS firmware v1.30: disable Charge Cycle Management (CCM) when a low voltage or SOC trigger is activated streamline the calculation of output / r...

Hi Andres, If the starter battery is only used to start the engine, it will not get much discharged and will be recharged by the alternator very rap...

Hello Leigh, No you do not have to reduce the charge current in normal situation where you start with balanced cells and the BMS only has to do mino...

Lithium batteries are not like lead-acid batteries. The cell voltage varies very little between 10 and 90% SOC : Therefore a cell voltage cannot ...

In short the answer is no. It would not be realistic or cost effective to take appart a drop-in battery and replace the BMS. Drop-in batteries can b...

@andreshs1 Yes the BMS is tested and packed (we test every unit and attach a test report before shipping)... ready to go. We are currently in a qui...

Note to all readers: I will close this thread as it starts to be a bit long and covers many different topics. Please open new topics for specific qu...

@mateo98 Il est préférable de mettre un lien vers l'équipement dont on parle afin d'éviter toute confusion. Je pense que tu parles de ceci: Apr...

@michel-leblais Oui, le BMS coupera la charge lorsqu'une tension de cellule atteint la tension maximale que tu auras fixée. Donc pas de risque de s...