Bonjour Michel, Merci pour cette info et le lien vers ce relais double. Ce relais peut être directement commandé par le BMS TAO. Les caractéristi...

That would be a question for Wakespeed as it does make any difference on the BMS side. My understanding is that the WS500 reads the SMA messages and...

Hi, There are two types of CAN integration with Wakespeed: the SMA messaging protocol that is also used by Victron: Testing and validation will...

Bonjour René, Oui le BMS TAO est tout à fait adapté pour une installation terrestre avec un parc de batteries jusque 48 volt. Il permet, entre aut...

The charge cycle management feature cannot interfere or override a command sent by a trigger (in your case the trigger you create for the enable heate...

The polarity option of the contactor is for the power terminals (+A1 / -A2). The need for a protection diode is on the red and black coil wires. T...

Always a pleasure to share knowledge so that you get the best possible experience when going to lithium. I never heard about this contactor before, b...

Good idea to standardize on Victron equipment so that the Cerbo GX can control all of them via CANbus. The Monitor for TAO BMS connects directly to ...

I like simple systems and I would go for a 4P4S configuration (single BMS, shunt, set of contactors...). The downside, as you say, is that the BMS do...

I also have a Victron solar regulator without the terminals for remote on/off. I have installed a small relay between the solar panel and the regulat...

Yes the Monitor front face is 3D printed. In a couple of weeks we will receive new overlays (matte/velvet Lexan polycarbonate, high definition revers...

Yes TAO BMS CAN communication is compatible with Wakespeed and Victron. We are working with Wakespeed to take it to an even more integrated level usi...

You need to set the "100% SOC reset" voltage parameter to match the parameters set on your chargers (bulk / absorption voltage). The charger starts c...

I, and many of my customers, use Winston cells - they have the same characteristics as standard LiFePo4 in many aspects. The major difference is that...

I like your practical thinking and many people would have the same requirement. The code for "current based triggers" already exists in the firmware,...