At the moment Charge Cycle Management has no option to limit current / voltage via CAN message. It is a good idea and it is not too hard to add (I re...

Wait until the red box goes away...

Do you confirm that ,on the battery measures screen, there is no red frame around the SOC value? The BMS SOC parameters are the criteria to decide w...

Hi @nor, Unfortunately there is no standard on shunt communication. Shunts from different manufacturers have different capabilities and proprietary...

Ce sera comme si vous aviez des cellules de 560Ah. Dans chaque groupe de cellules, les deux cellules en parallèle sont toujours équilibrées entre ell...

Bonjour Xavier, Une belle installation que vous préparez. Pourquoi deux parcs 24v (2 x 8S)? cela nécessite deux BMS et le double de pas mal de c...

I sent a message to American Power Systems to get the specification for the CAN messages needed to control the converter (ON/OFF, voltage and current ...

between 35% and 60% soc sounds good. In any case you should have many cycles during the 90 days.

Each balancer for a group of 4 cells moves energy from one of its cells to the next group of 4 cells (and the opposite to charge a cell). The cables ...

Q1. The TAO BMS supports the SAE J1939 CAN protocol standard. It communicates with Wakespeed WS500 using the SMA protocol (standard protocol 11 bit I...

Has the BMS already recorded a full charge since it has been turned ON? (no red frame around the SOC measure on the battery screen) Until the BMS h...

Sorry to hear about that situation. It looks like the cell wire harness for the BMS extension is not properly connected. Do you have a strain relief...

That link might interest you: How to tell the difference between Grade A and Grade B cells

Hello @ai_isyahoo-com, Thank you for sharing. It looks like you put a lot of thinking and planning in you installation. I have never seen such a d...