Hello Francoise, I have done today the FW Update 1.36 on the BMS 1st generation and the monitor update over the air. The access to the BMS Data is...

I am interested in how the problem was solved. Unfortunately no post with the solution is available. Jens

Is any body else having problems with the new firm ware? Can it be posted here, what the issue at fox kitty caused? I still have to do the firmware ...

Hello Françoise unfortunatly the access to the dashboard is still not available. Do you know when it will be reopened again? Maybe it will help to ...

Hi Andres, I had again a look on your Multiplus settings. Does it make sense to establish for the DC input low pre-alarm a voltage, which is a bit h...

Hello Philipe, happy new year! thanks for your quick return to my question on your high expert level. It shows, that the target to get a more safe s...

Hello Andres, this sounds not OK since the Inverter shuts down. I had overread in your post that the Multiplus is on "under voltage alarm" not "unde...

Hi Andres, my system is similar designed. I have the same behavior with Multiplus warnings „low voltage“ when high currents appear. Could find an e...

That’s good news. My expectation was around 100mA and this counts 72Ah in 30 days. If it is less than 0.03A the loss is only with 21Ah per 30 days. So...

Thank you for your reply. Do you know how much Amps the balancing board is taking from the battery/ cells ? Found somebody who went aboard to remove...

Thank you Phil for sharing your documentation and the schematic. I think both are brilliant and a lot of thoughts and experience are visible. We are...

Thank you for your thoughts and verification. I just found in the data history the same symptom at other SOC and voltage levels. (8.5.23, 3.11.22, 21...