Hi Tom, thank you so much for your deatailed advise. so I will try to control my Multiplus in this (back up)-way. wish you good progress with you...

How is it going on. Did you found any solution fitting to your setup? Iam keen to know about, because I will also upgrade for a Balmar Alternator and ...

Hello, to continue this topic I want to share my experience with balancing my LFP. It is a 460AH/12V, 2p4s. After winter pause and sea setting I s...

Hi Molly, it will work, as the LFP is also a source for charging the Starterbattery. A schematic of a running installation of your idea with a Balm...

Hi Tom, great description and share of experience. 👍 I am very interested in the use of the VE.configure two signal BMS assistant to control via t...

Hi Trevor, our installation controls two solar MPPTs with CanBus commands. MPPTs are connected by VE.direct cables to a Cerbo GX - and the Cerbo con...

…. and pls put some extra isolation, small pvc sheets, maybe from a file the plastic cover, between the cells and between the cells and the compressio...

Hello John, Your description of your system is very well written and understandable. We also had lack of mounting space at the bulkheads. So we hang...

Hi John, nothing to add to your answer. My opinion of the TAO BMS is the same and my next step in our installation will be a Balmar alternator to...

Hello, with very high interest, I’m following the actual discussion. I never have measured the heat of the resistor I have installed. But with the...

Hello Foxy Kitty, thanks for sharing your updates. It’s great to compare and to learn from. For the LED Signals my experience : If on trigger3 the...

Hi Tom, you can give the BMS device a name: open on the GX Touch for the Cerbo Menu ➡️ CAN-bus BMS battery ➡️ Device ➡️ Name press „name“ and...

Hi Phil, hi Tom in the VRM Portal of Victron Energy you can observe the current limits. See attachment. Cheers Jens

Hello Phil, thanks for your reply as you can see in my parameters attached, balancing should start when 3.4V of a cell is reached and the Voltage di...